What are the common techniques or precautions during the process of applying glass film? The correct film sticking method can not only prolong the service life of the film, but also ensure the beauty and practicality of the film sticking effect. Here are some common techniques and precautions during the process of applying glass film.

1、 Preparation work

Before applying the film, make sure you have all necessary tools, including scraper, spray bottle, art knife, ruler and clean rag. At the same time, choose a sunny day for the film application to avoid moisture and dust affecting the film effect.

2、 Clean the glass surface

Thoroughly cleaning the glass surface is the key to successful film application. Wipe the glass with glass cleaner and dust-free cloth to ensure that there is no dust or grease. After cleaning, wipe with alcohol to remove residual oil and bacteria.

3、 Measurement and cutting

Accurately measure the size of the glass and mark it on the film. When cutting, it is recommended that the size of the film be slightly larger than the size of the glass to adjust and avoid edge exposure.

4、 Spray lubrication

Before applying the film, spray enough water on the back of the glass and film to facilitate sliding and adjustment during application, while reducing the generation of bubbles.

5、 Film application techniques

Starting from one end of the glass, slowly and evenly apply the film onto the glass. Use a scraper to scrape flat from the center to the outside, removing bubbles and excess moisture. For stubborn small bubbles, they can be punctured with a needle and air can be squeezed out.

6、 Edge trimming treatment

After applying the film, carefully cut along the edge of the glass with a craft knife to ensure neat cutting. If the edge of the film is raised, it may be due to insufficient compaction during film application. You can use a scraper to re compact the edges to ensure they are tightly attached to the glass.

7、 Check and adjust

After the film is applied, carefully check the screen to ensure that there are no bubbles or dust. If everything is normal, you can start using it. Suggest letting the film dry naturally for 24-48 hours. During this period, try to avoid touching the surface of the film as much as possible to ensure that it adheres firmly.

8、 Regular cleaning

After applying the film, regularly cleaning the surface of the film can extend its service life. Use mild cleaning agents and a soft cloth to wipe the surface of the film, avoiding the use of cleaning agents containing corrosive ingredients.

9、 Avoid direct sunlight

Within a few days after applying the film, avoid exposing the film area to direct sunlight, as high temperatures may cause rapid evaporation of moisture between the film and the glass, affecting the bonding effect.

10、 Professional installation

For glass with large areas or complex shapes, it is recommended to have professional personnel perform the operation to ensure optimal results.